Helpful Hints:

Set Items you do not use to an extreme value. i.e. If you do not offer the HACGP door style then in D-Door Cost.pcb set the cost of this door to $800/sqft. This will flag the door style for your designers as one you do not carry.

KCD recommends checking your price accuracy as often as possible while editing and setting up your pricing method. This will help in determining price errors. To fix this you would check the last things you have edited for typos or other inaccuracies since the last time you edited your pricing. If you have only changed a few things, then backtracking your changes will only involve checking a few things. However, if you have made many changes then you will need to look over all of those changes. Because of that, it is recommended that you make only a few changes, then check the prices, then make a few more changes. This will make finding mistakes much easier.

* Remember to include odd or specialty sizes you might not offer all the time.

Closet Price List Checklist:

  • Go to A-Setup.pcb. Answer all of the questions on this page. If you do not offer an accesory, do not worry about typing in a price for this item leave the default settings.
  • Go to B-Side Cost.pcb. If you have selected to use a lookup list, make sure to read the instructions on this page carefully. Start with the smallest side you offer.*
  • Go to C-Shelf Cost.pcb. Again make sure to read the instructions on this page carefully. Start with the smallest shelf you offer.*
  • Draw up a simple closet design on the drawing screen. Make sure there are 2 different interior widths of units on the screen.
  • Go to Price, highlight your pricing method on the left, and on the right highlight !! KCD Closet Contract, click on Calculate.
  • Look at the closet component prices on the screen, make sure they are coming out correct for these units.
  • If your bottom piece is showing an incorrect cost, you should write down the dimensions of the piece then go back to the C-Shelf Cost.pcb file to look for the mistake.
  • Below is a list of additional files you will need to go into and edit:
    • D-Door Cost.pcb
    • E-Drawer Cost.pcb
    • F-Basket Cost.pcb
    • G-Pullout Cost .pcb
    • I-Molding Cost.pcb